ABB VFD fault codes

일반적인 원인

• Acceleration too fast
• Motor or cable fault
• Damaged power stage

확인 사항

• Disconnect the motor cable and run the drive without load: if the fault stays, the drive itself is faulty
• Megger the motor and cable for insulation or phase-to-phase faults
• Increase acceleration/deceleration time; check for mechanical jams

일반적인 원인

• Deceleration too fast
• Supply overvoltage
• Brake chopper not working

확인 사항

• Increase the deceleration time or enable the stall/overvoltage prevention function
• Check the braking resistor and braking transistor (if fitted)
• Measure the supply voltage – it should be within the drive's rating

일반적인 원인

• Fan failure
• Blocked heatsink
• High ambient temperature

확인 사항

• Clean the heatsink and check that the cooling fan runs
• Check the panel temperature and ventilation
• Reduce the load or carrier frequency

일반적인 원인

• Short circuit in the motor or cable
• Failed output IGBT

확인 사항

• Disconnect the motor; if the fault remains, the drive needs repair

일반적인 원인

• Supply phase missing or low voltage
• Blown fuse

확인 사항

• Measure all three input phases under load
• Check input fuses, contactor and loose terminals
• If the supply is fine, check the DC bus capacitors and pre-charge circuit

일반적인 원인

• Motor overloaded
• Poor motor cooling

확인 사항

• Check the load, motor fan and motor data

일반적인 원인

• Motor or cable insulation failure

확인 사항

• Megger the motor and cable to earth
• Check for water or dust in the motor terminal box
• If insulation is fine, the output IGBT or current sensor may be faulty

일반적인 원인

• Missing phase
• Aged DC capacitors

확인 사항

• Measure all three input phases under load
• Check input fuses, contactor and loose terminals
• If the supply is fine, check the DC bus capacitors and pre-charge circuit