Yaskawa VFD fault codes

常见原因

• Short circuit or earth fault on the output
• Acceleration time too short
• Damaged IGBT or current sensor

检查内容

• Disconnect the motor cable and run the drive without load: if the fault stays, the drive itself is faulty
• Megger the motor and cable for insulation or phase-to-phase faults
• Increase acceleration/deceleration time; check for mechanical jams

常见原因

• Motor or cable insulation failure
• Moisture in the motor

检查内容

• Megger the motor and cable to earth
• Check for water or dust in the motor terminal box
• If insulation is fine, the output IGBT or current sensor may be faulty

常见原因

• Deceleration too fast
• High or unstable supply voltage
• Braking resistor missing or faulty

检查内容

• Increase the deceleration time or enable the stall/overvoltage prevention function
• Check the braking resistor and braking transistor (if fitted)
• Measure the supply voltage – it should be within the drive's rating

常见原因

• Low supply voltage or phase loss
• Faulty pre-charge circuit

检查内容

• Measure all three input phases under load
• Check input fuses, contactor and loose terminals
• If the supply is fine, check the DC bus capacitors and pre-charge circuit

常见原因

• Fault in the drive's internal power supply (SMPS)

检查内容

• Check the 24 V control supply and external loads on it
• Usually needs control/power board repair

常见原因

• Faulty pre-charge relay or resistor

检查内容

• Needs power board inspection

常见原因

• Fan failure or blocked heatsink
• High ambient temperature

检查内容

• Clean the heatsink and check that the cooling fan runs
• Check the panel temperature and ventilation
• Reduce the load or carrier frequency

常见原因

• Motor overloaded
• Wrong motor rated current setting

检查内容

• Check E2-01 (motor rated current) and the load

常见原因

• Load too high for the drive
• Carrier frequency too high

检查内容

• Reduce load or carrier frequency, or use a larger drive

常见原因

• Missing supply phase
• Loose input wiring
• Aged DC bus capacitors

检查内容

• Measure all three input phases under load
• Check input fuses, contactor and loose terminals
• If the supply is fine, check the DC bus capacitors and pre-charge circuit

常见原因

• Broken motor cable or winding
• Loose output terminal

检查内容

• Check motor cable continuity and terminals
• Measure the motor windings

常见原因

• Output short circuit
• Failed IGBT

检查内容

• Disconnect the motor and test: if SC remains, the IGBT/power board needs repair

常见原因

• Control board fault
• Electrical noise

检查内容

• Check grounding and shielding
• Repeating CPF errors need control board repair